Today we worked on a new ball intake system, where we utilized a (probably original because we've never seen any other robot do this) 'technique' to structurally enhance the robot. The first one we used was to use spacers and axle lockers to keep our axle form falling out of our motor clutch. Using spacers, we managed to put axle lockers directly in front of the motor and use spacers to even it out. We also created a suitable conveyor belt which we would attach tomorrow. This new robot has lots of promise!
0 Comments
Leave a Reply. |
Archives
April 2016
Categories"Uhhh, Guys?"-Scott "YOU ARE TESTING MY PATIENCE" - Daniel "Guys, get to work"-Tom "What should we do???"-Jeff & Eric "GIMME SOMETHING TO DO!!" -Eric "WHAT ARE YOU DOING?!?"-Daniel "Jefferytheengineer" "CLEAN UP CLEAN UP EVERYBODY CLEAN UP" "OMG. ERIC IS ACTUALLY WORKING"- Everyone |